R3VLimited Forums

Go Back   R3VLimited Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.22 seconds.
Search: Posts Made By: Digitalwave
Forum: Alternative Tuning / W.A.R / Megasquirt / etc Today, 08:50 AM
Replies: 12
Views: 146
Posted By Digitalwave
I tried a bunch of different resistors and didn't...

I tried a bunch of different resistors and didn't find much if any change. You do need a 10-20k resistor based on most of my research. You can read my experience here:...
Forum: Alternative Tuning / W.A.R / Megasquirt / etc Today, 06:38 AM
Replies: 12
Views: 146
Posted By Digitalwave
First try different resistors (you did already)....

First try different resistors (you did already). Next replace the CPS with a new OEM metal CPS and set the air gap properly (1.0mm). MS is picky about how good the signal is, much more than Motronic....
Forum: Track & AutoX 06-12-2019, 07:48 AM
Replies: 10
Views: 372
Posted By Digitalwave
Surge tank.

Surge tank.
Forum: The Project Forum 06-11-2019, 01:33 PM
Replies: 243
Views: 26,876
Posted By Digitalwave
I haven't trimmed those. The one that fits the...

I haven't trimmed those. The one that fits the worst is the one from the water pump to the top of the thermostat, but it's not that bad.

Thanks for the kind words all!
Forum: The Project Forum 06-11-2019, 10:20 AM
Replies: 243
Views: 26,876
Posted By Digitalwave
Some pictures from Cars & Coffee last weekend....

Some pictures from Cars & Coffee last weekend. Photo credit to Mike Melnick.


https://live.staticflickr.com/65535/48044618663_42df8538f2_b.jpg
...
Forum: The Project Forum 06-10-2019, 02:06 PM
Replies: 243
Views: 26,876
Posted By Digitalwave
Time for a little update. Not a lot has happened...

Time for a little update. Not a lot has happened since the last. From the last track event all I really needed to do was to change out the front rotors, install some brake ducting, and do a nut &...
Forum: Parts For Sale 06-10-2019, 01:11 PM
Replies: 3
Views: 471
Posted By Digitalwave
Still have one of these left.

Still have one of these left.
Forum: Parts For Sale 06-10-2019, 01:10 PM
Replies: 52
Views: 15,010
Posted By Digitalwave
Bump. OP is up to date.

Bump. OP is up to date.
Forum: Parts For Sale 06-10-2019, 01:10 PM
Replies: 3
Views: 453
Posted By Digitalwave
I still have both. Make offers!

I still have both. Make offers!
Forum: Parts For Sale 06-10-2019, 01:09 PM
Replies: 5
Views: 868
Posted By Digitalwave
Anybody need any of this stuff before it gets...

Anybody need any of this stuff before it gets thrown out?
Forum: Track & AutoX 05-31-2019, 03:24 PM
Replies: 184
Views: 41,422
Posted By Digitalwave
Absolutely awesome and inspirational. Keep it up!...

Absolutely awesome and inspirational. Keep it up! Can't wait to see past updates fill in.
Forum: Alternative Tuning / W.A.R / Megasquirt / etc 05-31-2019, 02:53 PM
Replies: 28
Views: 4,955
Posted By Digitalwave
Tooth #1 angle should be 84* give or take. You'll...

Tooth #1 angle should be 84* give or take. You'll have to verify your actual tooth #1 angle using a timing light to be sure (mine was about 84.6* to be absolutely perfect). This would make your...
Forum: Parts For Sale 05-17-2019, 12:31 PM
Replies: 7
Views: 329
Posted By Digitalwave
This is a steal.

This is a steal.
Forum: Parts For Sale 05-17-2019, 11:53 AM
Replies: 2
Views: 270
Posted By Digitalwave
SOLD: GarageWelt "Brilliant Evo" E30 M3 Skate Deck

SOLD SOLD SOLD

GarageWelt Brilliantrot Sport Evo on an M Rain background. New, still in clear plastic wrap.



https://live.staticflickr.com/65535/46954186035_630e8c113a_b.jpg
Forum: Track & AutoX 04-30-2019, 09:25 AM
Replies: 9
Views: 299
Posted By Digitalwave
You can probably increase the tire pressures...

You can probably increase the tire pressures quite a bit, since autocross is too slow and too short to build up heat in the tires, they are not going to raise the pressures much at all. I'd try...
Forum: Track & AutoX 04-30-2019, 09:12 AM
Replies: 9
Views: 299
Posted By Digitalwave
Just a couple random thoughts: - H&R Sports...

Just a couple random thoughts:

- H&R Sports are really soft and understeer prone

- Stiffer rear bar may help some

- M3 CABs reduce low speed steering response

- The 25mm MC increases...
Forum: Parts For Sale 04-30-2019, 09:06 AM
Replies: 3
Views: 453
Posted By Digitalwave
I don't know. These are primarily for heads that...

I don't know. These are primarily for heads that were shaved down to the point that the timing and compression are off.
Forum: Parts For Sale 04-29-2019, 09:02 AM
Replies: 27
Views: 2,529
Posted By Digitalwave
And if you didn't sell them yet, did you ever...

And if you didn't sell them yet, did you ever test fit them?
Forum: Track & AutoX 04-26-2019, 09:22 AM
Replies: 9
Views: 848
Posted By Digitalwave
Just wanted to update this thread now that I have...

Just wanted to update this thread now that I have had the car on the track for 3 events with the 25mm E32 master cylinder. The brake bias is MUCH better, and it really transformed the braking on the...
Forum: The Project Forum 04-25-2019, 01:54 PM
Replies: 243
Views: 26,876
Posted By Digitalwave
Those sold quite quickly to a local concourse...

Those sold quite quickly to a local concourse type of car actually. Glad they went to a good home!
Forum: The Project Forum 04-24-2019, 03:34 PM
Replies: 243
Views: 26,876
Posted By Digitalwave
I'm honestly not sure what I would do if/when...

I'm honestly not sure what I would do if/when something happens to this motor. At 2400lbs and 210whp I am more than happy with the power level. I'd love to see what a really crazy M20 build could do,...
Forum: The Project Forum 04-24-2019, 02:24 PM
Replies: 243
Views: 26,876
Posted By Digitalwave
Well, a lot has happened since the last update!...

Well, a lot has happened since the last update! Let's dive in.

First off, I finally bit the bullet and got a vehicle capable of towing and bought a trailer. I have accumulated so much stuff that I...
Forum: Alternative Tuning / W.A.R / Megasquirt / etc 04-12-2019, 01:14 PM
Replies: 144
Views: 28,026
Posted By Digitalwave
On TunerStudio dashboard you can add a gauge that...

On TunerStudio dashboard you can add a gauge that shows you sync loss count. That's the easiest way to see if you are losing sync, besides the tooth logger. It should basically have no sync loss...
Forum: The Project Forum 04-12-2019, 12:48 PM
Replies: 32
Views: 1,575
Posted By Digitalwave
Too much effort (and $$) to go proper 5 lug,...

Too much effort (and $$) to go proper 5 lug, leave it as is!
Forum: Alternative Tuning / W.A.R / Megasquirt / etc 04-10-2019, 07:27 AM
Replies: 144
Views: 28,026
Posted By Digitalwave
If you don't have any sync loss, it's not the...

If you don't have any sync loss, it's not the CPS. It's probably breaking up because it's untuned.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -7. The time now is 11:22 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC