R3VLimited Forums

Go Back   R3VLimited Forums > Search Forums

Showing results 1 to 25 of 30
Search took 0.01 seconds.
Search: Posts Made By: angelfire
Forum: M20 05-07-2019, 06:54 PM
Replies: 3
Views: 171
Posted By angelfire
Misfire and loud valves/knocking sound

Help! I have adjusted the valves several times on my m20 at the eccentric and the cam. My valve noise is still super loud and it has quite a prominent misfire at idle. I have tried 0.010 and 0.008...
Forum: M20 04-27-2019, 10:16 PM
Replies: 6
Views: 258
Posted By angelfire
I donít drive the car much but when I do, the...

I donít drive the car much but when I do, the highest I have seen is about 16 mpg according to the on board computer. Thatís city driving. When I pull the spark plug wires off, all cylinders make the...
Forum: M20 04-25-2019, 06:43 PM
Replies: 6
Views: 258
Posted By angelfire
Stubborn misfire

I recently replaced all the vacuum lines and gaskets on the intake side of my m20 along with adjusting the valves for the 3rd time (they are still quite noisy. I adjusted at the eccentric and the...
Forum: General Technical 04-14-2019, 06:21 PM
Replies: 0
Views: 77
Posted By angelfire
Strange lock problem

I recently swapped my drivers door lock and ignition lock with used units as the ones in my car were no longer working. After getting everything installed, I noticed my car locks in an abnormal way....
Forum: Parts For Sale 04-14-2019, 03:42 PM
Replies: 59
Views: 2,104
Posted By angelfire
Set of locks and keys?

Set of locks and keys?
Forum: M20 03-16-2019, 08:16 PM
Replies: 4
Views: 163
Posted By angelfire
I think confirmed it. Itís a fuel related issue....

I think confirmed it. Itís a fuel related issue. I just tried to crank it over (engine was about 60 degrees C or 140 degrees F) but stopped before it fired up, aprox 3 seconds of cranking. Cranked it...
Forum: M20 03-16-2019, 05:15 PM
Replies: 4
Views: 163
Posted By angelfire
My car is a 1987 325is. I recently just cleaned...

My car is a 1987 325is. I recently just cleaned the IM and injectors but not a deep clean. Iím starting to learn that these cars for for sure not like my Honda Accord haha. I did test the coolant...
Forum: M20 03-16-2019, 03:23 PM
Replies: 4
Views: 163
Posted By angelfire
More Running Problems with my E30

So I thought I got the 220k m20 sorted out, but turns out it was too good to be true. I recently just replaced the Throttle Position Switch, as my car was idling really high. She now idles at the...
Forum: Springs, Shocks, Sways & Steering 03-08-2019, 05:01 PM
Replies: 8
Views: 237
Posted By angelfire
Could it be the subframe or steering rack?

Could it be the subframe or steering rack?
Forum: Springs, Shocks, Sways & Steering 03-07-2019, 06:56 PM
Replies: 8
Views: 237
Posted By angelfire
Iíll have to check again. Stlll confused as to...

Iíll have to check again. Stlll confused as to why my alignment is way off now
Forum: Springs, Shocks, Sways & Steering 03-07-2019, 06:40 PM
Replies: 8
Views: 237
Posted By angelfire
I tried that but the mtech 1 wheel only lets you...

I tried that but the mtech 1 wheel only lets you put it on one way
Forum: Springs, Shocks, Sways & Steering 03-07-2019, 06:05 PM
Replies: 8
Views: 237
Posted By angelfire
I checked under the car and I didnít see anything...

I checked under the car and I didnít see anything broken. I know Iím not very good with cars Iím still new to all of this I just havenít ever seen this happen before
Forum: Springs, Shocks, Sways & Steering 03-07-2019, 04:45 PM
Replies: 8
Views: 237
Posted By angelfire
Steering wheel WAY off

Hi all
I have a project 87 325is that has been on a pair of jack stands for a few months until today when I finally got it running. But when I went to go drive the car, I immediately noticed the...
Forum: M20 03-07-2019, 01:23 PM
Replies: 9
Views: 344
Posted By angelfire
Alright, I measured the TB and it IS 55mm. Upon...

Alright, I measured the TB and it IS 55mm. Upon further investigation, it for sure doesnít mate to the intake manifold like it should. Totally didnít even notice until now DERP. If anyone wants to...
Forum: M20 03-06-2019, 08:09 PM
Replies: 9
Views: 344
Posted By angelfire
Bump. Anyone have ideas? This is so bizarre. I am...

Bump. Anyone have ideas? This is so bizarre. I am sure I have the right intake manifold and throttle body. I got a TB gasket off of ECS and it fits right up. But the boot doesnít fit. I am stumped
Forum: Parts For Sale 03-06-2019, 05:36 PM
Replies: 3
Views: 485
Posted By angelfire
Pmíd

Pmíd
Forum: M20 02-26-2019, 07:51 PM
Replies: 9
Views: 344
Posted By angelfire
Thanks for the replies everyone. My intake...

Thanks for the replies everyone. My intake manifold for sure looks like the one off of an “i” car. I cross checked the part number off of the old intake boot and it comes back to a 320i..... That car...
Forum: M20 02-25-2019, 07:11 PM
Replies: 9
Views: 344
Posted By angelfire
Intake problem

Hey everyone, I have a rather strange problem. I have an 87 325is which comes with the ďLĒ shaped IACV. The previous owner for some reason put the ďTĒ shaped valve on instead, as well as changing the...
Forum: Parts Wanted 01-17-2019, 04:40 PM
Replies: 1
Views: 108
Posted By angelfire
WTB: Late Model Shift Linkage

I need a shift linkage for an 87 325is. Getrag 260
Forum: Parts For Sale 01-17-2019, 04:38 PM
Replies: 23
Views: 1,193
Posted By angelfire
PM me about extra shift linkage.

PM me about extra shift linkage.
Forum: Parts For Sale 01-17-2019, 12:35 PM
Replies: 23
Views: 1,193
Posted By angelfire
How much for the shift linkage?

How much for the shift linkage?
Forum: Parts For Sale 01-03-2019, 10:40 AM
Replies: 42
Views: 2,804
Posted By angelfire
Do you still have the shift linkage??

Do you still have the shift linkage??
Forum: Parts Wanted 12-29-2018, 10:11 AM
Replies: 1
Views: 117
Posted By angelfire
Bump

Bump
Forum: Parts Wanted 12-15-2018, 08:29 PM
Replies: 1
Views: 117
Posted By angelfire
WTB: Early Model Shift Linkage

I need the shift linkage for a 1987 325is. Stock getrag 260.
Forum: Parts For Sale 12-15-2018, 08:24 PM
Replies: 42
Views: 2,804
Posted By angelfire
Do you have the shift linkage for sale?

Do you have the shift linkage for sale?
Showing results 1 to 25 of 30

 
Forum Jump

All times are GMT -7. The time now is 10:28 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC