R3VLimited Forums

Go Back   R3VLimited Forums > Search Forums

Showing results 1 to 7 of 7
Search took 0.01 seconds.
Search: Posts Made By: ForcedFirebird
Forum: M20 01-04-2018, 01:55 PM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
Based on the HP number, it would appear to me...

Based on the HP number, it would appear to me that the o2 number is correct, but also a cam tooth off would do similar (your TQ curve looks weird for an m20).
Forum: M20 07-31-2017, 03:56 AM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
180whp shouldn't be an issue. I just did that...

180whp shouldn't be an issue. I just did that with a m52 crank eta rods, "i" pistons, 272 cam, stock valves/ports and a dyno tuned chip.
Forum: M20 03-15-2017, 08:33 AM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
If everything is clean, you shouldn't need a...

If everything is clean, you shouldn't need a puller. Usually a little rust, grime, or galling for the key is what's holding them on (or all three hehe).
Forum: M20 12-13-2016, 04:26 PM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
Try some electrical solder. I find it works much...

Try some electrical solder. I find it works much better than clay (specially playdoh which is really too soft, I use modeling clay), and it holds the shape, much easier to use a caliper.

.050" is...
Forum: M20 11-07-2016, 11:41 AM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
As per your PM (displayed public for future...

As per your PM (displayed public for future searches since it's a common question):



I have been following your thread ;)

NOTE: This is my personal opinion based on experience, not rule/law....
Forum: M20 09-14-2016, 12:06 PM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
Make sure you weight match pistons after.

Make sure you weight match pistons after.
Forum: M20 08-28-2016, 08:06 AM
Replies: 88
Views: 8,274
Posted By ForcedFirebird
I have done this with no ill effects. Just be...

I have done this with no ill effects. Just be sure to weight match the pistons after.



But do the connecting rod big ends/bolts clear as well? They make the swing if the crank a little larger.
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -7. The time now is 06:27 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC