R3VLimited Forums

Go Back   R3VLimited Forums > E30 Technical Forums > Engine & Drivetrain > Alternative Tuning / W.A.R / Megasquirt / etc

Reply
 
Thread Tools Search this Thread
Old 08-07-2018, 10:34 AM   #16
Digitalwave
is a poseur
 
Digitalwave's Avatar
 
Join Date: Oct 2003
Location: FL
Posts: 5,461
M20B25 should be a 60-2 (60 minus 2, 2 teeth missing) crank wheel and your tooth #1 angle should be 84* give or take a degree or so. You'll need to lock the timing to test with a timing light (try 0* or 10* of fixed timing, then set your timing gun accordingly). I've never heard of other setups on M20B25's, unless something aftermarket was installed.

How is your VR signal? Are you having any sync loss? You can verify this using the tooth logger. Are you already doing tuning? What is your AFR like? You might want to try posting your full MSQ file here.
__________________
Digitalwave is offline   Reply With Quote
Old 08-07-2018, 03:40 PM   #17
slothonaleash
Member
 
Join Date: Sep 2014
Location: Columbus, Ohio
Posts: 88
My VR signal is good according to this:
https://www.diyautotune.com/support/...megasquirt-vr/

Lots of small bars followed by a bar three times the size of the small bars--all uninterrupted.

My AFR at idle is 11.0.. pig rich right. When I apply throttle, it immediately breaks up and I peg full lean.

I hate to sound uneducated, but how do I go about posting the MSQ file?

Thanks a million for your time by the way; this is why I proudly sport a r3v sticker on my car, for better or for worse...
slothonaleash is offline   Reply With Quote
Old 08-08-2018, 07:15 AM   #18
Digitalwave
is a poseur
 
Digitalwave's Avatar
 
Join Date: Oct 2003
Location: FL
Posts: 5,461
It's obviously hard to diagnose something like this over the internet, but if all things are configured properly, then it could just be that it's untuned. If it's idling that rich, it could be a rich misfire (which shows up as lean on the wideband, as it's only reading oxygen). It's time to start tuning, I think. Check your plugs and see if they are fouling.
__________________
Digitalwave is offline   Reply With Quote
Old 08-11-2018, 07:40 AM   #19
varg
R3VLimited
 
varg's Avatar
 
Join Date: May 2014
Location: Palm Beach County, FL
Posts: 2,047
RE: coil getting really hot
The ignition output setting "going high" might be incorrect for your unit, going low would probably fix that issue.

As for it idling rich and misfiring when you rev it, make sure your req fuel value is correct. If it is, scale the VE table until it runs right, assuming the base tune is any good it should run well enough to drive and tune after that. I doubt you can upload logs or msq files to this forum, you'll have to use a third party service like google drive.
__________________
@turbovarg
'91 318is, M20B25, T3/T04E 60 trim (15psi), megasquirt, coilovers, Z3 rack, cold AC
[b u i l d]
[Car of the month: April 2018]

Always outnumbered, never outgunned.
varg is offline   Reply With Quote
Old 08-12-2018, 04:20 PM   #20
slothonaleash
Member
 
Join Date: Sep 2014
Location: Columbus, Ohio
Posts: 88
The ignition issue was solved with a new MS. After taking a bunch of fuel out of the low end of the VE table, I am now up and running

Thanks guys!
slothonaleash is offline   Reply With Quote
Old 08-13-2018, 07:45 AM   #21
Digitalwave
is a poseur
 
Digitalwave's Avatar
 
Join Date: Oct 2003
Location: FL
Posts: 5,461
Have fun tuning!
__________________
Digitalwave is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 01:01 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC