R3VLimited Forums

Go Back   R3VLimited Forums > E34/E28 Forums > General 5 Series Technical

Reply
 
Thread Tools Search this Thread
Old 06-09-2019, 02:05 PM   #1
d1rty_e30
Noobie
 
Join Date: May 2013
Location: Chicago
Posts: 21
e24 m50 swap, e36 325i getrag

Hi guys, i am nearing the completion of my swap with the driveshaft that is only left for my car to drive on its own. Here is what i've already tried to miss match to see if it will bolt up.


e36 325i driveshaft is 4 inches too short in the rear.
e28 m20 manual drive shaft fits but its really spread out and only goes into the splines about an inch and i am afraid to break it.



The distance from output flange to input flange of diff is 64-65 inches. I've seen that e30 318i either m10 or m42 front portion is the right size that would bolt up with my e24 rear half.



Need opinions or suggestions on what to do. Thanks!
d1rty_e30 is offline   Reply With Quote
Old 06-29-2019, 11:03 AM   #2
hendrixvodu
R3VLimited
 
hendrixvodu's Avatar
 
Join Date: Jan 2007
Location: RI
Posts: 2,501
Have the drive shaft extended and re balanced that’s what I did when I manual swapped my 740
__________________
-His-
87 e30 325i
87 e24 m6
05 e83 x3
94 e32 740i 5spd
-Hers-
89 e30 325i
18 f48 x1
hendrixvodu is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 01:29 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2004 - 2020 R3VLimited LLC